Waterproof cement grouting Non Shrink Cement Grout for interior /
Non-shrinkage grouting material is high strength material as an
aggregate (such as: quartz sand, Silicon carbide, etc.),use the
cement, grout masterbatch as the medium, made from high flow, micro
expansion, segregation and other admixture.
1. It is precast in factory that could be used by adding water.
2. It is not contain metallic materials which could cause rust.
3. It has high strength and long durability in the early period.
4. It has good artesian function, rapid hardening, less than 1
5. It is not contain chloride that could avoid the corrosion to the
steel and bolt.
6. It can be construction by drying filling, tamping surface,
scrape, dump and pumping.
Scope of application
1. It is suitable for flow type grouting materials, precast or
pre-casting folder and the grouting of the column.
2. It can be used to fill the holes and defects of concrete and
joint cracks between the blocks. As well as concrete joint, cable
car track and mechanical support, etc.
3. It is used for the secondary grouting of the installation of
steel column and equipment.
4. It can be used for anchor bolts grouting, slab grouting,
concrete hollow of concrete precast installation and repair
grouting of crack defects.
5. It is suitable for the paste grouting of large stone and tile
6.The toughening type is suitable for installation of large general
equipment with strong vibration, basic secondary grouting (large
ore crusher, large-scale ball mill, heavy hammer, cold rolling
mill, conveyors, power transmission tower, bridge bearings, steam
turbine generator sets, large paper machine, crane track and gantry
crane rails, etc.)
Treatment of base plane
It should be clean, strong, and free of grease, dust, powder and
other loose materials.
Bolts and nuts should be cleaned.
The concrete base materials should be pre-wet but without clear
water before construction.
- Stir with enough water using the high-speed electric stirrer for 5
- The product should be used with 30 minutes after stirring in
- The thickness of non-shrinkage grouting should be between 20 and
150mm. Prohibit to increase mobility by the mechanical vibration
which could avoid the segregation phenomenon.
The exposed parts should be covered by wet cloth or plastic film
after the construction to prevent excessive evaporation.
Erosion to Iron Bar
Bleeding Rate (%)
Initial Setting Time (min)
Final Setting Time (min)
Keep in cold and dry place, unopened product is valid for 1 year.
Office:Room 1709, Jingying Building,No.316 Huanshizhong road,Yuexiu
Tel:020-83550760 Fax:020-22810051 Web:www.yunyanchina.com
Panyu factory:Guanqiao Industrial zone shilou Town Panyu District,Guangzhou.
Yunfu factory:Yunan Industrial zone Yunfu district,Guangdong.
Chongqing factory:Shapingbeige Leshan Industrial zone,Chongqing.
Changsha factory: Lituo Industrial zone,south high speed rail station,yuhua
1. Brand Owner’s Authorization Letter is required to be issued
& provided for the corresponding production and exportation;
2. Quality only based on the samples which the buyer provided or
YUNYAN’s counter-sample confirmed by buyer.
In every case, the user alone is fully responsible for any
consequences deriving from the use of the product.
3. OEM MOQ: at least 1*20 feet container per item/color.
4. Printery mold fee: USD250 for 3000 bags at least.
Package cost: USD0.40/bag
Printing lead time: 12-15days