Premixed Strong Adhesive Repairing Cement Mortar Concrete
1. Extremely low water demand, have good early strength.
2. Excellent bonding power, reduce the old and new mortar's
3. High density, good waterproof performance. Reduce permeability
of chloride and carbon dioxide, protect building's main structure
4. Low shrinkage, reduce cracking.
5. Easy construction so that improve the efficiency.
6. Non-toxic and tasteless, it does not contain solvent,
Scope of application:
It’s suitable to repair concrete exfoliation caused by
reinforcement corrosion; repair the structural defects or concrete
components part; fill in the gap between the decorative window.
Base treatment: Before construction, cut into the maintenance scope
about 10 mm with cutting machine, chiseling all loose concrete
away, remove rust iron thoroughly, and remove dust on the surface
of the concrete, And then coated with repair mortar interface agent
on the steel surface. If the base plane is dry completely before
plastering repair mortar, must be clean with water thoroughly and
plaster again, and then can plaster the repair mortar.
Stirring: mix mortar with quantitative water (add water gradually),
stirring with the right type of blender mixing about 5 min, until
evenly without block.
Construction: Put and overwhelm the repair mortar with a spatula or
with artificial construction directly on the base plane of the
coating interface. In general, the thickness of single-layer is 30
mm, if the coating is so thick that it drops down, you must wipe
out the affected parts. And plastering a thinner mortar on it
again. Thicker parts maintenance need to daub in multilayer daub
manner. Please scrape the next coating after the first coating is
Maintenance: Exposed surface need to maintenance after
construction, it can use the suitable curing agent, watering
continuous and other maintenance ways.
1. Should clean and wet the base plane before construction.
2. The stirred slurry should be finished within 4 hours.
3. Avoid construction below 5 ℃, 40 ℃ above environment.
4. The layer is completed, should be natural maintenance more than
3 days, can do the next working procedure construction.
5. Don’t use the dried paste by re-adding water.
Execute standard JG/T 336-2011
Testing Items Testing description Standard requirement and result
Setting time Initial/min ≥45
Compressive strength / Mpa 7d ≥10.0
Flexural strength/ Mpa 7d ≥4.0
Tensile adhesive strength/Mpa No treatment 28d ≥1.0
In water 28d ≥0.8
25times freeze-thaw cycle 28d ≥0.8
Shrinkage ratio % 28d ≤0.10
Avoid direct sunlight and storage on plate from the ground.
12 months stored in the cold and dry place.