Exterior Plaster Wall Filler Putty Super Adhesion Flexible For
Basecoat wall putty is a double/single-component thin-set mortar
based on special high resistance binders, selected special
additives and formula.
■ It has good two-way compatibility and high shear bond strength.
■ It is ready-mix product, only need to mix with water or latex.
■ It has good thixotropy, even and smooth.
■ It has excellent crack resistance and water resistance.
■ The leveling facing is exquisite, smooth.
■ It is non-toxic and harmless, no radiation.
Scope of application
■ It is suitable for leveling of special rough inorganic plane
outside the building, including mortar plaster, concrete, standard
block, and brick and so on.
■ Matching paint: water, oil paint, stone paint, and inorganic
Treatment of base plane
■ The base plane should be smooth and strong; no dust, grease,
release agents, batik materials and so on.
■ If the base place is very uneven, leveling it with powder putty
for exterior wall for one time. The new plastered cement mortar
surface should be maintained for more than 14 days before
■ If the weather is hot and dry or the porosity of base plane is
high, construction should be done after water the base level and
waiting until no clear water.
■ The construction should be done from 5 ℃ to 40 ℃.
■ Control strictly about putty proportion of water and powder,
avoid appear product too loose, too low strength because of too
much water; or product dry fast and too low strength because of too
■ If adding too much water when stirring, should add more powders.
■ The mortar should be used within 4 hours.
Stir with motor stirrer until even, standing for 5-10 minutes, and
stir again will get better result.
Product name YY-612 general YY-622 general double component) YY-625
strength double component YY-626 srenew double component YY-628
Mix the powder and water in the proportion
Construction tools Container, motor stirrer, putty knife, spray and
coating tool and grinding tool, etc.
Construction time interval(hr) >4
Construction thickness(mm) 0.8-1.5